Kval 990-H, Service Manual

Page: 12 / 104

Overview of the 990-H Door Hanging System
KVAL 990-H Service Manual
1-4
Options and Specials Available
Option Title Description
Opt ND Narrow Doors Narrow door system adds mechanism and pro-
gramming to automatically accommodate doors as
narrow as 410mm in width, but without lock pro-
cessing (Option includes complete secondary feed
fence attached to the lock section of the 990-H that
will nest under doors when not in use)
Opt P Single Point Hinge Pre-Drill Option includes three single spindle motors (one
for each hinge) with programmed motion to pre-drill
holes in succession for hinge screws. The screw
pattern is saved and recalled by name. The cycle
adds approximately 5 seconds to that of the multi-
ple spindle pre-drill. (Requires Corner Squaring
option.)
Out-Feed Pause Switch Adds an out-feed pause switch to the button panel
attached to the center screw-driving head to tem-
porarily over-ride automatic door out-feed. Allows
screws to be added or replaced with a hand held
screwdriver.
Programmable Hinge Loca-
tions This option upgrades the standard air cylinder shift
system for hinge positions along the door edge.
The cylinders and three position limit is replaced
with servo motors, ball screws and software to
adjust the outer hinge routers to any location within
the limits of the ball rail track.
Programmable Door Index
and Hinge Applicator Posi-
tioning This option compliments the programmable hinge
location option by also adding four more servo
motors, ball screws and software control to adjust
door positioning stops and the left and right hinge
application heads. This will make it possible to eas-
ily create presets on the touch screen for multiple
door lengths, hinge locations and lock locations –
or completely custom locations can be entered for
one time use. Top hinge location can vary from
198mm and screwdrivers can be aligned with cus-
tom hinge locations.