About Calibration
KVAL 990-F4 Operation Manual
2-42
Using the Adjustment Menus
Located in the setup screens are adjustment menus. In these menus you can add negative or posi
-
tive adjustments to move a cutting assembly to the desired position.
• Enter the data in the white box below the parameter.
• The
Base
display box keeps a running total of data entered to help keep track of the
changes.
• The
Combine with Base
button stores data in memory and should be used at first to
set a reference and at final to store data.
.
FIGURE 2- 16.
Sample of an Adjustment Menu
Enter a Positive or Negative Number?
Determine when to enter a positive of negative number by using your
Left Hand
.
Use the cut on the door as a reference.
Looking into the cut from the front of the machin
e.
• Hold out the left hand with the first finger pointed at the door, second finger and
thumb at right angle to each other.
• The first finger represents the
positive
direction of the ‘Z” axis,
• The thumb represents the
positive
direction of the ‘Y” axis
• The Second finger represents the
positive
the direction of the ‘X’ axis.
Title:
of assembly to adjust
Parameter:
to adjust (X,Y,and or Z
axis.)
Offset:
Select this button to add or
subtract the measured number
entered.
Base:
Keeps a Running Total of
measured numbers entered.
Enter:
Enter measured data
Combine Base:
Select this
button at
start
of adjustment
to set a reference and
end
of adjustment to store it.
Y-
X Axis Positive
movement
Z Axis Positive
movement
Y Axis Positive
movement
Z -
X +
Y +
Z +
X -