ProLaser III Operator's Manual
Page
31
The operator obtains a range by aiming the unit at a
target and pulling the trigger. The range will appear in the
area next to “Dist1”. After a suitable range is obtained,
press ENTER.
This action activates the second screen which appears
below-
If the second point is where the operator is standing,
simply press ENTER and the ProLaser III will use Dist1 as
the total distance. The operator obtains a second range
by aiming the unit at a target and pulling the trigger. The
range will appear in the area next to “Dist2”. After a
suitable range is obtained, press ENTER. Note that
“Distance too short” appears if the range difference is less
than 300 feet. The difference between the two ranges will
appear on a screen as below:
NOTE: The operator and the two aiming points must
be in a straight line for the distance
measurements to be accurate.
The user can increase or decrease this range using the
unit’s arrow switches. When complete, press ENTER.
This will activate the Audio control menu, which allows
the user to enable or disable the audio alert prompts
during the stopwatch function. Use either blue arrow
switch to make the selection and press ENTER. The
“stopwatch ready” screen will be displayed.
STPW Measure
Dist2
1120 feet
