ProLaser III Operator's Manual
Page
33
CORDLESS OPERATION
The ProLaser III may be operated with the supplied
corded handle plugged into a 12 VDC power source, or it
may be operated with the optional cordless battery
handle. To change to the battery handle, unscrew the end
of the corded handle by turning counterclockwise with a
“push and turn” motion. Insert the battery pack into the
handle and screw in with a “push and turn”. There is only
one way the pack will fit into the handle so that the cap
will screw down, thus assuring proper power connections.
When the battery pack’s power becomes too low for
operation (the Low Voltage Alert or Low Voltage Warning
will appear on the display), unscrew from the handle of
the ProLaser III and recharge by inserting it into the
charger and attaching it the same way as is done in the
handle. Plug the charger into a wall outlet and allow to
charge for 4-5 hours (standard charger). When the
battery pack is fully charged, the charger will cease
charging in order not to harm the battery pack.
It is a violation of Federal regulations to dispose of
dead batteries in a landfill. They must be recycled at an
appropriate facility or otherwise disposed of in accordance
with local ordinances, or they may be shipped back to
Kustom Signals for disposal. For more information on
disposal facilities near you, contact the Rechargeable
Battery Recycling Corp. (RBRC) at 1-800-8-BATTERY, e-
mail [email protected], web page www.rbrc.com.
