Studio Descriptions
16
Studio Descriptions
800 mLAN Overdub
-Analog inputs 1-4 are selected as In 5-8 on the INSEL page. These are then sent to mono FX
buses 5-8, then to mLAN outs 5-8. They also go to Mix 3-4 which goes out analog 3+4, providing no latency
monitoring directly through the KSP8.
Inputs 1-4 select mLAN inputs 1-4, which go through FX bus 1-4, then to Mix 1+2 which goes out Analog 1+2.
This provides monitoring of your DAW tracks. (You can send your DAW tracks to either mLAN1+2 or 3+4,
depending on whether you wish to apply different EQ/FX to them or not).
on your DAW:
select mLan inputs 5-8 on your DAW to record ksp8's 4 analog inputs.
select mLan 1-4 as outputs for DAW channels for monitoring.
Send the KSP8s 4 analog outputs to 2 pairs of stereo channels on your mixer. Use the second pair for no-latency
monitoring of your inputs while monitoring your DAW off the first pair.
801 mLAN Overdub 1+2
-(Some entry level or demo DAW software may allow only 2 channels of mLAN I/O.
This studio will be useful if this is your scenario).
Analog inputs 1+2 are selected as In 1+2 on the INSEL page. These are then sent to mono FX buses 1+2, then to
mLAN outs 1+2 and analog outs 1+2, providing no latency monitoring directly through the KSP8.
Inputs 3+4 select mLAN inputs 1+2, which go through FX bus 3-4, then to Mix 1+2 which goes out Analog 3+4.
This provides monitoring of your DAW tracks.
on your DAW:
select mLan inputs 1-2 on your DAW to record ksp8's first 2 analog inputs.
select mLan 1-2 as outputs for DAW channels for monitoring.
Send the KSP8s 4 analog outputs to 2 pairs of stereo channels on your mixer. Use the first pair for no-latency
monitoring of your inputs while monitoring your DAW off the second pair.
802 mLAN 6FX&Monitor
-send six channels from your DAW on mLAN 3-8 for effects processing. Return these
six channels to your DAW on mLAN 3-8. Assign your DAW's main stereo output to mLAN1-2, which will go to
KSP8 analog outputs 1+2 for monitoring.
803 mLAN StDrms>8Out
-put a stereo drum mix into analog inputs 1+2 and record 4 stereo pairs onto your DAW
using mLAN 1+2, 3+4, 5+6 and 7+8.
804 mLAN Mn Vox>8Out
-put a mono source (like a vocal) into analog input 1. The 8 mLAN outputs will have
four mono and 2 stereo signals:
mLAN1-dry
mLAN2-compressed
mLAN3-mono filtered/delay chain
mLAN4-distorted
mLAN5+6-stereo chorus
mLAN7+8-stereo room reverb
Studios 805-820
-these studios are the same as the base ROM studios found at IDs 1-99, but with mLAN inputs
used instead of analog inputs. Since these studios take mLAN inputs and provide mLAN outputs, you will find
them useful when mixing down in your DAW, and you have some other means of monitoring.
