20
EKI 607/807
Installation above a Küppersbusch built-in electric oven.
■
Should the built-in cooking surface be operated with an oven installed
underneath, only Küppersbusch built-in baking ovens with appliance cooling
are permitted.
■
The worktop must be 40 - 50 mm thick so that the aerial guide between
built-in baking oven and worktop can be correctly installed. If the installation
depht is not reached the aerial guide cannot be installed. If it is exceeded
the aerial guide is not effective.
– Place the foam mouldings on the oven.
The enclosed mouldings are slit. Parts of the foam are to be torn off so that
the step created by the oven is offset, see next illustration.
– Also adhere the front right with a quarter of the bigger torn-off piece of
foam moulding, see next illustration.
– Insert the protruding foam between the cooker and the worktop.
– Seal the openings in the ventilation area in the oven top with the enclosed
adherent strips.
– Important: Pay attention to the sealing. It is important not to create an air
short circuit between inlet and outlet side.
Installation above a drawer, only with acc. no. 136.
The induction hob may only be built in above a drawer with the air baffle plate -
accessory no. 136.
– The air baffle plate should be attached in accordance with the instructions
for accessory no. 136.
Only for ceramic-tiled worktops
– Clean the surfaces, apply the sealant in a continuos strip and press the hop
into the opening.
– Remove excess sealant by cutting and clean the sealed surface immediately
with water.
Installation of the hob
Using clips makes it easier and quicker for you to install these units. You can
carry out the complete installation work from above:
■
Always lift the hob by holding it at the sides. Do not lift it by the front bar.
■
Be extremely careful when installing the glass ceramic cooking surface!
Do not place or drop any sharp or pointed tools (screwdrivers etc.) on the
glass surface!
■
The glass ceramic hob must have a level and flush bearing. Any distortion
may lead to fracture of the glass panel.
– Make sure that the sealing of the hob is properly seated. If the worktop
surface is uneven (tiles, etc.), remove the sealing strip and seal with a
heat resistant sealing compound.
– Then insert the clips into the worktop cut-out as shown in the figures
shown in the diagram, observing the clearances indicated. It is not
necessary to adjust the height due to the horizontal stop motion device.
– Position the hob according to the illustration on the left side (1), align it
(2) and insert the clips (3).
Should the worktop recess have been cut
out slightly too large, it is possible to
increase the pre-load of the clips by
screwing.