EEH 6200.0
29
Installation instructions for fitter
■
Küppersbusch fitted ovens may only be connected to the corresponding
Küppersbusch fitted hobs by a qualified and authorised fitter.
■
Statutory regulations and the connection specifications issued by the local
power supply company must be strictly observed.
■
When carrying out repairs the unit must be disconnected from the mains.
Disconnect the fuse.
■
It must not be possible to touch components which are insulated under
operating conditions.
■
The appliance may be connected only to a properly installed cooker socket.
Installing and wiring a cooker socket or replacing the connection cable should
only be performed by an electrician and in observance of the relevant
regulations.
■
Safety regulations require that an all-pole isolator with a contact opening of at
least 3 mm be used on the installation side.
■
This appliance can be placed with its back wall and one side wall next to
cupboard or room walls of any height. The other side may only be placed
next to a fitted cupboard of the same height at the most.
■
Built-in kitchen fixtures must be temperature resistant up to 100 °C. This
applies especially to veneers, plastic coatings, adhesives and varnishes.
Adjacent cabinetry front must be temperature resistant to at least 70 °C.
■
The unit must be installed absolutely horizontal on a level, solid base. The
base must not be allowed to sag.
■
If the cupboard element is not attached to the way, screw on using an
ordinary bracket.
Electrics
Built-in cooker
Permanent connection by means of a cooker socket.
Hob
Connected via the cooker connection strip.
Circuit diagram
for the various mains ratings is illustrated on the
back wall of the appliance.
Total rating
at 230 V: max. 10.8 kW, of which
oven: 3.5 kW,
hob: max. 7.3 kW (depending on the type)
at 235 V: max. 11.2 kW, of which
oven: 3.6 kW
hob: max. 7.6 kW (depending on the type)
Electrical connection
Permanent connection: 400 V 3 N
~
50 Hz
Connection 3 N
~
Fuse current 20 A
Connection 2 N
~
Fuse current 30 A
Connection 1 N
~
Fuse current 35 A
Connection 3 x 230 V Fuse current 25 A
Connection cable
use H 05 RR-F or H 07 RN-F.
Cable length
at least 2 m
Installation dimensions
Installation in a fitted kitchen
Installing the appliance
– Insert the appliance a short way into
a cupboard alcove.
– Press the correctly positioned
electrical hob connection into the
oven connector strip as far as it will
go.
– Push the oven right into the cupboard
alcove. Do not jam the cooker
connection!
Fastening the appliance:
– Open the oven door and fix the screws
supplied at an angle through the
cupboard.
