Kuppersbusch EDG6260, User Manual, Page: 7 / 30

32
EN
Basic settings
Initial Settings
After your steam oven is first plugged in or after a power
failure, the clock display will flash to indicate that the time
shown is not correct.
The oven will not operate until the clock is set and the water
hardness parameter is set. To set the clock and the water hardness parameter value
proceed as described in the following chapters.
Setting the clock
00:00
1,3,5
2,4
To set the clock, proceed as follows:
1. Press the
OK key. The hour numbers will start to flash
(not necessary if your oven is first plugged in or after a
power failure).
2. Turn the rotating knob +/- to set the correct hour value.
3. Press again the OK key to set the minutes. The minute
numbers will start to flash.
4. Turn the rotating +/- knob to set the correct minute value.
5. To finish, press the OK key again.