Kuppersbusch EDG6260, User Manual, Page: 21 / 30

46
EN
Care and maintenance
Descaling procedure
Warning: For safety reasons, the descaling process
cannot be interrupted and it takes about 45 minutes.
The appliance can be descaled with the appliance door open
or closed. The appliance must be in idle state prior to starting
the descaling cycle.
To run a descaling cycle proceed as follows:
1.
Press the Descale key for about 6 seconds. The display
shows “ CAL ” and there is an intermittent beep.
2. Press the Start/Stop key.
3. When the display shows “ 0.5L ”, remove the water tank.
4. Pour 0.5 litres of an adequate descaling solution into the
water tank and put the water tank back.
5. Press the Start/Stop key. The Descale cycle is initiated
and takes about 30 minutes.
6. When the display shows “
1.0L ” flashing and the oven
emits a beep, remove and empty the water tank.
7. Fill the water tank with 1.0 litres of cold water and put the
water tank back.
8. Press the Start/Stop key. The first rinsing cycle starts.
9. When the display again shows “ 1.0L ” flashing and the
oven emits a new beep, remove and empty the water
tank.
10. Fill the water tank with 1.0 litres of cold water and put the
water tank back.
12. Press the Start/Stop key. The second rinsing cycle starts.
13. When the rinsing cycle has finished the display shows
“ End ”.
14. Remove, empty and dry the water tank.