Kuppersbusch EDG6260, User Manual, Page: 12 / 30

37
EN
Water feeding
Filling the water tank
All functions require the water tank to be full.
Fill the water tank up to the ”MAX” mark with cold, fresh
drinking water and introduce it into the slot located above the
cavity (approximately 1L).
If the indication “rES” appears, it means that the water tank
was not properly inserted.
Refilling the water
The contents of the water tank normally suffice for one
cooking session of 50-60 minutes.
If, however, the water tank needs to be refilled, the Water
refill light switches on.
00:00
Only fill the water tank up to a maximum of 0.5 litres to
ensure that the water does not overflow when it is
pumped back to the water tank. RISK OF OVERFLOW.
Emptying the water tank
When the appliance is switched off, the residual water is
pumped back into the water tank.
While the water is being pumped the display shows “PUMP”.
This message stays on until the temperature of the water
reaches 75º C before it can be pumped back to the water
tank.
Warning: the water in the tank may be hot. Danger of
burns!
After the water is pumped back to the water tank, the display
will show the message “DEP” requiring the following actions:

Remove and empty the water tank.

Dry the water tank and introduce it back into the slot
located above the cavity. Clean and dry the cooking
space.

Leave the appliance door open so that the cooking
space can cool down and dry completely.
IMPORTANT NOTE: It is advisable to remove the water
tank and empty it after a cooking cycle. This prevents
the formation of bacteria and limestone inside the
appliance.
If the water tank has not been removed from the oven and a
new cooking cycle is started, the oven displays the warning
“
DEP ”.
This warning can be cleared by pressing the Stop key and
proceed with the new cooking cycle without removing and
emptying the water tank.