Kuppersberg FG 63, Technical Passport, Page: 12 / 52

12
TECHNICAL PASSPORT ENGLISH
Gas hob
SECTION 6.
INITIAL PREPARATION AND INSTALLATION OF YOUR TABLE
TOP COOKER
CautionI!
Never use lighter or match for gas leakage controlI Sealing control:
Make sure the buttons are in off position and the cylinder is not open. For gas
leakage control, apply soap solution to the connection end of the hose. If there is
any gas leakage, you will see bubble on the soapy part. In such case, check the gas
connection again.
Initial preparation and
installation of liquefied
petroleum gas -fueled Cooker
(Optional).
As your cooker is set to liquefied pe -
troleum gas (cylinder), there is a hose
end on your cooker for connection to
liquefied petroleum gas (cylinder). Do
not run the gas hose of your cooker
around the hot surfaces.
Keep the end of the plastic hose you
will use for connection between your
cooker and liquefied petroleum gas
pressure-reducing valve in the boiling
water 1 minute to soften it and then
attach the hose end into its place com-
pletely. Tighten the clamp firmly.
Perform the same process for the
other end of the hose and attach to the
liquefied petroleum gas pressure-reduc -
ing valve.
Have your product attached to the
liquefied petroleum gas (cylinder) cock
in such a way not to cause any leak-
age. Definitely have it checked for
sealingThe plastic hose to be used
should not be longer than 125cm for
safety purpose. Your product is set to
liquefied petroleum gas (cylinder). When
you use your product with liquefied
petroleum gas, use a TSE-certificated
pressure-reducing valve with pressure
outlet 1.5kg/300mm SS. To switch your
product to natural gas, call the author-
ized service center.
Initial preparation and
installation of Natural Gas
fueled Cooker (Optional).
As your cooker is set to Natural Gas,
there is a hose end on your cooker for
connection to Natural Gas. Have the gas
hose of your cooker attached to the nat-
ural gas cock without any deformation.
Definitely have it checked for sealing.
The spiral hose to be used should not be
longer than 125cm for safety purpose.
Please call authorized service center to
switch your product to liquefied petro -
leum gas (cylinder).