Kuppersberg FA6VS02, Technical Passport

Page: 5 / 32

5
english Technical passporT
electric hob
Precaution. It is dangerous
to cook with fat or oil without being
present, as these may catch fi re. Never
try to extinguish a fi re with water! In
this case disconnect the appliance and
cover the fl ames with a lid, a plate or a
blanket.
Do not store any object on
the cooking areas of the appliance .
Preventa possible fi re hazard.
Do not use plastic pots or
alliminium sheets
Do not use hob as a
supplamentary surface
Dry the bottom of the pot before
put in on the cooking zones
Do not scrape the pot against
the glass to avoid damaging it
Use pots with the same diameter
of cooking zones
USe
COOKTOP CONTrOLLeD bY
TOUCH CONTrOL
The graphical display is shown
in (fi gures 1). As you see, the diameters
and thus the powers of heating elements
vary as shown in Table 1. Heating
elements are controlled by this control
unit with 9 positions. When supply
voltage is applied the hob control unit
carries out an automatic calibrat ion
procedure. The hob is thereafter in
stand-by mode.
All the heat zones are switched off
and t he display are not illum inated.
The desired heating element can
now be selected by using the 4,5,6 or
7 sensors for related heating elements
(see fi g. 1). Heat settings of the
selected heating element adjusted by
using the (-) sensor which is shown
as»3»in Figure 1 to reduce, (+) sensor
which is shown as «2» in Figure 1 to
increase the heat level.
There are 9 heat setting modes
starting from 1 to 9. «1» is the minimum
and «9» is the maximum mode.
You can see the suggested cookings
in Table 2.
When a heating element has been
switch off by means of on/off sensor, an
«H» appears on the illustrated display
to show that the heating element is still
hot for 30 minutes in order to avoid any
accident.
For the hobs included dual zone
heating elements.
Outer part of dual zone heating
element could not work separately.
There are two possibility, one is using
inner part of the heating and the other
one is using both. Inner part of it can
be activated by pushing related control
unit however to activate the whole
heating element, it is needed to push
related control unit for inner part fi rst
and then related control unit of outer
part.