Kuppersberg FA6VS02, Technical Passport

Page: 13 / 32

13
english Technical passporT
electric hob
To obtain these changes, please,
follow the instructions:
a) Take the therminal box cover
making pressure on the sides clamp as
indicate in the fi gure stamped on the
cupboard (see fi g. 13).
b) Remove the connection jumpers
on the clamp following the scheme of
page 16 (attached on the body).
c) Insert the input cable with
adequate section (Table 6) into the
chock.
d) C onnect the phase cable into
the clamp and the «earth» cable in the
relative clamp.
e) H old up the input cable with the
pertinent stop cable.
f) Close the cupboard again and
press until the closing turn.
MAiNTeNANCe
before doing any action, disconnect
the appliance from the input power.
COMPONeNTS SUbSTiTUTiON
To replace the components lodged
in the internal part, is necessary to take
the appliance up from the fauwrnaiytu
trhee, obvoettrotumrn. it, loosen the
screws and take
After the se actions, it’s possible to
work on the plates, commutators and
clamps.
For the maintenanc e of the cable
it’s necessary to overturn the hob.
In case of substitution of the input
cable, the installer must keep the
«earth» conductor longer than «live»
ones, and must respect the cautions in
paragraph «ELECTRICAL CONNECTION».
To reassemble the appliance repeat
the inverse process.
TeCHNiCAL CHArACTeriSTiCS
OF THe eLeCTriCAL COMPONeNTS
To facilitate the job of the installer we
present a table with the characteristics
of the components.
TAbLe 6
TYPe AND SeCTiON OF THe POWer
CAbLeS
MODEL
Single
Phase
Cable
FA6VS01 -
FA6VS02
3X2.5
mm2(*)
H05SS-F
(*) keeping in mind the diversity factor
FIG. 13