Kunzle & Tasin STORNELLO 7699950001, Operating Manual And Safety Instructions

Page: 7 / 24

7
Operating manual STORNELLO ®
Commencing operation
HAZARD
Using the machine when not fully assembled may cause injury or damage to people or
objects. Do not use the machine when it is not fully assembled. Keep all fittings tightly
closed. Maintain machine settings in accordance with the specifications.
Instruction for electrical connection
CAUTION
This machine only operates with the voltage and frequency shown on the machine data
plate. Before connecting the cable to the power supply ensure the correct voltage and
frequency are available.
WARNING
Do not expose the machine to rain. This machine, when suction is supplied, is intended
for dry use only. The machine can work with water splashes in the contact zone between
the sanding surface and the plate when it is not equipped with suction.
Do not immerse cables and other electrical components in water.
Keep the machine in a dry building and do not use it in damp or wet places.
WARNING If the machine is not connected correctly to the electricity network, death due to
electrocution may occur. To prevent electrical shock always use a grounded three wire
electrical system. For maximum protection against electric shocks use a circuit protected
with a differential cut-out switch.
WARNING Tampering with the grounding plug in any way may result in death from elctrocution.
Do not cut, remove or break the grounding plug. If the socket does not match the plug
consult a qualified electrician.
WARNING Do not use the machine if the switch does not open and close.
HAZARD
If the machine is used with the plug or power cable, death may occur from electrocution.
If cables or plugs are worn or damaged in any way, have them replaced by the
manufacturer or by the technical service K&T or by a person with similar qualifications,
in order to prevent risks to safety.
Cables, extensions and plugs
Use only approved cables. The maximum recommended cable length is 10 meters; for greater lengths use cables with
a larger cross-section.
CAUTION
Using the machine with unsuitable cable cross-section and/or excessively long cables
may cause injury or damage to people or objects.
WARNING The machine must never be moved using its cable and the cable must never be pulled
when disconnecting from the socket.
WARNING
Keep the cable away from source of heat, oil and sharp edges.
WARNING
MACHINE WITH 230V
∼
50Hz MOTOR
The power supply cable must be approved HAR designation HO5VV-F 2x0,75 mm
2
For versions other than the European consult an authorized K&T distributor.