Installation of the Module
Installation Instructions
2
cRIO PN-Installation-V0.3/12.05.2017
Business Confidential/
Proprietary
2 Installation of the Module
The cRIO PN module is a PROFINET IO Device module for National Instruments
CompactRIO system. The configuration entirely takes place by means of the delivered
software. Thus, no jumpers or DIP-switch adjustments are necessary.
To mount the module in the CompactRIO system, please proceed as follows:
Switch off the CompactRIO system
Plug the cRIO PN module into slot 1 until it snaps in
Pay attention to a proper adjustment of the board in the guidance (avoid canting!).
Important note:
The cRIO PN module requires 1.7 W of power, so you must use it in Slot 1
while leaving Slot 2 empty.
Important note:
The cRIO PN module is supported only in CompactRIO reconfigurable
chassis, such as an NI cRIO-911x, and NI Single-Board RIO devices.
Figure 1: cRIO PN module
