Before using PTS, following must be selected.
(1) Selection of Transmission Mode ( Transmission Model is optional ).
There are 2 types of PTS models. Transmission model and non-transmission model.
If non-transmission model, select either mode below.
① PRINTER MODE [ Prn ] ・・・・・・・Connect the printer ( option ) to out put the result on thermal paper.
② PC MODE
[ PC ] ・・・・・・・Connect a computer to transfer results
(2) Selection of [ Automotive ] Mode
[ Automotive ] and [ Industrial ] can be selected purposely.
application
Automotive Mode
Industrial Mode
Panel Display
Aut
Ind
Direction
Right / Left handed screws
Right handed screws only
Maximum Torque
Up to the pre-set torque
Up to the pre-set torque
Maximum Torque
Up to the pre-set torque
Up to 500 Nm
for loosening
selected currently
Press ③ of the display panel
How to set
[ - L - ] will be shown.
Turn the reverse lever to LEFT.
loosening
To continue loosening works,
The Loosening Mode is automatically set.
please press ③ again.
(To turn the reverse lever, fastening mode
( This loosening function only works
again)
1 bolt/nut)
(3) On / Off of the abnormal fastening detection [ CH1 ] **
Select [ CH1 ] on or off.
◎ Purposely add this function for fastening wheel nuts.
It may detect [ CH1 ] even after fastening general bolts or nuts if the automotive mode is selected.
** Please see page 14 for further information of [ CH1 ].
Preparation (2)-①
Initial Setting ( Description )
