● Error Code Description on PTS main unit ( troubles on the main unit )
Error Code
Panel Display
Causes
Measures
Malfunction of the torque sensor causes
Please contact your dealer.
E01
the misalignment of ''zero point''.
The sensor detects the abnormal uprising
Please check the surface of screws
E02
of the torque higher than the pre-set
and grease and fasten again.
torque.
However [E02] is still shown on
the panel, please contact your
dealer.
Low batteries
Please replace with new batteries.
Lo
● Error Code Description on fastening
Error Code
Panel Display
Causes
Measures
If [ CH1 ] is turned on,
CH1
Please see the next page [ Troubleshooting (3) ].
(CHECK1)
Result below pre-set torque
Releasing the throttle lever before reaching Please loosen the nut once and try
Under
the pre-set torque.
to fasten again.
Torque
(The figure shows 120Nm when releasing
the throttle lever).
● Error Code Description on loosening
Error Code
Panel Display
Causes
Measures
[ when loosening mode is selected]
Please loosen bolts/nuts by
The loosening torque excesses the maximumimpact wrenches.
torque.
Trouble Shooting (2)
Description of error code
