3 - 10
Power supply
3.3.2. Grounding
On the base plate of the device (see "3.1.1. Top view", pos. 10a)
there is a threaded bolt of dimensions M4 x 15 mm with two
nuts for connecting the grounding wire with the frame ground.
wire diameter
wire diameter
wire diameter
wire diameter
wire diameter
recommended:
4 mm
²
minimum:
1.5 mm
²
Capacitive ground connection of the supply voltages
Capacitive ground connection of the supply voltages
Capacitive ground connection of the supply voltages
Capacitive ground connection of the supply voltages
Capacitive ground connection of the supply voltages
For reasons of operational safety, the 0V potential of the KUAX
680C has a capacitive connection to the frame ground. High-fre-
quency interferences can bleed off via this connection.
Shielding of data lines
Shielding of data lines
Shielding of data lines
Shielding of data lines
Shielding of data lines
The connector casings of interfaces RS 232/1 and RS 232/2 and
the "Shield" connectors of the RS 485 interface are directly
connectrd to the frame ground. We recommend using these po-
sitions for connecting the shields of the data lines. Possible in-
terference signals can thus bleed off without causing any dam-
age.
Connect the basic device to ground via the grounding pin to
render these measures effective. Always choose the shortest pos-
sible connection.
Summary of Contents for KUAX 680C
