KUHN Venta 3030, Operator'S Manual

Page: 124 / 136

Venta 3030-3530-4030
122
12. - Troubleshooting guide
RN034AGB D
Seed Drill
Placement of seeds is too
flat, deep or irrgular
The position of the parallelogram
is incorrect
The parallelogram is not adjusted
in a homogeneous way
Adapt the position of the latch pin at
the level of the parallelogram
See section Coulter bar
adjustment, page 73
The machine is not properly
aligned or horizontal Align the machine with the spirit
level
The latch pin at the level of
the parallelogram turns with
difficulty or adjustment is not
possible
The length of the hatch pin is
different on the right and on the left
Align the two sides of the coulter
bar in a homogeneous way using
the scale markings on the ratchet
pin
The latch pin is fulled with dust or
jammed
Blow compressed air into the latch
pin via the cavity at the level of the
adjustment lever
Inject grease in grease nipple
No tramlining
Battery insufficiently charged Charge the battery
Faulty cable or no connection
Replace cable
Connect connector
The tramlining shut-off valves are
dirty or blocked
Clean shut-off valves
The PAUSE key has been
activated Press the function button (Pause)
on the work screen
The hopper cover does not
close properly. The closing system is not properly
adjusted. Adjust the lock using the lacing on
the cover lock.
The blower has not reached
the rating.
The flow divider is not working
properly.
Shut-off the flow divider, adjust the
tractor speed and slowly open the
flow divider.
The tractor's oil supply is
insufficient.
Fully open the tractor control valve
and proceed again with the
adjustment.
Vario blower
The blower has not reached
the rating.
The pressure filter is clogged (The
indicator sticks out). Replace the filter cartridge. See
section
Oil change, page 114
Problem Cause Remedy