32
Machine specifications
Tedder-rake combination
HAYBOB 300
Preparing the tractor
-
5. Attachment to the tractor
Since the hitch brackets are reversible, the hitch frame is
suitable for both cat. I and II.
Cat. I: small diameter pins on the outside.
Cat.II: large diameter pins on the outside.
If necessary the PTO drive shaft between the tractor and
machine should be shortened to prevent damage when
it is in its shortest position.
- Check the length of the PTO drive shaft, shorten the
drive shaft if necessary.
Care must be taken to ensure the PTO drive shaft is not
shortened too much, see the instructions that come with
the PTO drive shaft.
Dependent on the length of the top link, either the front
or the rear hole in the hitch frame can be used.
Top link and draft links must be as parallel as possible.
Check prior to attaching the machine wether the draft
links are on the same level.
The tractor must be fitted with lower link stabilizers.
for easier attachment and pitch angle adjustment, we recommend to use a hydraulic top link.
In this case, an additional double acting outlet is required.
Prior to attaching the machine to the tractor,
ensure the draft links are on equal level!
Always use stabilisers or check chains when
attaching the machine to the tractor, to
prevent sideways movement of the hitch
frame damaging the pto drive shaft.
