KUHN GA 4311 GM, Assembly & Operators Manual

Page: 26 / 40

- 24 -
OPTIONAL ACCESSORIES
1° WARNING BOARD AND LIGHT KIT (No. 113 6300 + No. 113 6350)
For safer road transport. To assemble, proceed as follows :
- Fix the 2 signalling panel holders (6) on the rear hinges (2) by means of 4 hexagonal screws (7) (M 12 x 35), 4
conical spring washers (M 12) and 4 self-locking nuts (M 12), as shown on photo 32.
- Fit the 2 warning boards (1) on “U” shaped supports (9) of rear hinges (2) and on brackets (8) using 6 hexagonal
bolts (3) (M 10 x 25) and 6 self-locking nuts (M 10) (photos 32 and 33). Make sure that the stripes are correctly
positioned (the top right and left corners must be red).
- Fit right tail light (4) marked “R” on the rear face of the right warning board (seen in the forward direction).
- Fit left tail light (5) marked “L” (and also a white mark) on the rear face of the left warning board (seen in the forward
direction).
- Set up wiring harness (L) using 4 (2 of them being attached together) clamp collars (K) (length 508 mm / 20")
and 5 clamp collars (O) (length 350 mm / 14") (photos 32 A and 33).
NOTE : - A 7 pin electric socket (8) is required at the rear of the tractor to operate this warning board and light
kit (photo 32 A).
- When parking the machine, insert the electric socket in hole (9) on the tine arm racks (photo 32 A).