8. - Instructions for work
FC243RGII
51
KN041BGB A
Mower conditioner
8.2
Adjustments in working position
8.2.1 Cutting height
The desired cutting height is obtained directly by
adjusting the top link length. The height can be
adjusted from 30 to 80 mm (1.1’’ - 3.1’’) (according
to the tractor).
To obtain a different cutting height:
- Place the machine in transport position.
- Lower the machine on the ground to remove weight
from the top link.
- Modify the top link length to alter the machine tilt
angle.
- Use mowing unit lift cylinder to lift the mowing unit.
- Place the machine in working position
- Check cutting height.
The maximum cutting height (L1 = 60 mm (
2.4’’
))
is obtained when the discs are parallel to the
ground.
The minimum cutting height must not be below
(L2 = 30 mm (
1.2’’
)).
Too low a cutting height can lead to:
- Excessive disc and knife wear.
- Crop being contaminated by soil.
- Delay in regrowth.
L1
L2
Summary of Contents for FC243RGII
Page 2: ......
