- 34 -
CHANGING ROTORS
b) CULTITILLER rotor with angled blades
(photo 42)
The
CULTITILLER
rotor is equipped with angled left
and right blades, solidly housed in individual supports
welded on the rotor tube.
Start fitting blades on the support nearest the side
gearbox. A left blade should be fitted first (cutting
edge facing the left in the forward direction). Then fit
a right blade on the support opposite the left blade. Fit
all blades like this, alternately left and right The last
blades fitted should be the one nearest the right end
shield.
The cutting edges of all blades should face the
direction of rotor rotation.
Tighten the nuts to a torque of 24 daNm
(177 ft.lbs)
on all
CULTITILLER
angled blades.
Outer blades
: 2 outer left blades should be fitted on the left drive flange and 2 outer right blades should be fitted
on the right flange. Each outer blade is assembled using 3 bolts (M16), tightened to a torque of
24 daNm
(177 ft.lbs)
.
c) CULTITILLER rotor with forged points
(photo 43)
This
CULTITILLER
rotor is fitted with forged points
bolted on supports individually welded on the rotor
tube.
The cutting edge of the forged points should face the
direction of rotor rotation.
Tighten the nuts to a torque of 24 daNm
(177 ft.lbs).
Outer blades
: 2 outer left blades should be fitted on
the left drive flange and 2 outer right blades should be
fitted on the right flange. Each outer blade is
assembled using 3 bolts (M16), tightened to a torque
of
24 daNm (177 ft.lbs).
d) CULTIPLOW rotor with angled blades
(photo 44)
The
CULTIPLOW
rotor is fitted with right and left
angled blades bolted onto flanges welded on the
rotor tube. Each flange has 4 blade supports (2
supports for left blades and 2 supports for right
blades).
Start fitting the blades on the flange nearest the side
gearbox.
Put left blades in the supports welded on the left face
of the flange and right blades in the supports welded
on the right face of the same flange. Fit all the blades
like this so that all left and right blades are fitted
helicoidally.
Tighten the nuts to a torque of 24 daNm
(177 ft.lbs)
on all
CULTIPLOW
blades.
Outer blades :
2 outer left blades should be fitted on the left drive flange and 2 outer right blades should be fitted
on the right flange. Each outer blade is assembled using 3 bolts (M16), tightened to a torque of
24 daNm
(177 ft.lbs).
Summary of Contents for EL 131
