KUHN EL 131, Assembly & Operators Manual

Page: 31 / 48

- 29 -
14° HARD COATED PACKER ROLLER SCRAPER PLATES
These scraper plates, which are particularly resistant to wear and tear, are available as replacement parts under
part n° 525 600 00 .
15° NYLON CLEANING PLATES FOR PACKER ROLLER SCRAPERS
Part No. 525 702 00
These cleaning plates are made from a supple synthetic material which enables them to be slightly pre
compressed against the roller for improved cleaning action.
a) Installation and adjustment (photo 30) :
Place the nylon cleaning plate (part number 525 702
00) between two new and unused steel scraper
plates (S) (part number 525 321 30) acting as carrier
plates. Bolt this assembly onto the laterally adjustable
scraper supports (M) with one cup square bolt (V)
(M10 x 35 -part number 500 073 00) and its nut.
Allow the nylon cleaning plate to stick out of the
carrier plates by 10 mm and press it slightly against
the roller so that its leading edge is in contact with the
roller segment across its full width. Rotate the roller
one complete turn to check that there is no gap
between roller and nylon cleaning plate. Re-adjust
the plate if this is not the case. Also check that the
upper carrier plate is set parallel to the roller segment
and does not come into contact with it.
b) Use :
The nylon cleaning plate is particularly recommended for light, loamy or chalky grounds with little crop residue
or stones. A correct cleaning plate adjustment results in a clean and shiny roller area across the full width of the
cleaning plates.
Soil deposit on the roller will result in premature cleaning plate wear. Readjust them quickly. The cleaning plate
is reversible for increased service life.
16° PTO SHAFTS
Depending on the profile of the tractor PTO stud, the PTO shaft can be ordered with the following tractor end
yokes :
- diameter 1 3/8" -
6 splines :
part no. 4600 502
- diameter 1 3/8" - 21 splines :
part no. 4600 504
- diameter 1 3/4" - 6 splines :
part no. 4600 506
- diameter 1 3/4" - 20 splines :
part no. 4600 508
17° ROTORS COMPLETE
The EL 131 can be equipped with 5 different rotors :
Power Tiller rotor with curved blades : No. 120 8720 for 2.50 m / 8’2"
No. 120 8760 for 3.00 m / 9’10")