KUHN AXERA-M, Operator'S Manual

Page: 12 / 46

12
2. Preparation of the fertilizer spreader
Take special care when attaching/detaching the fertilizer spreader
to/from the tractor.
2.1 Attaching to the tractor
The fertilizer spreader AXERA M can be attached to Cat.II tractor linkages. At-
tachment to Cat.III tractor linkages is only possible using Cat.II geometry and plac-
ing reduction sleeves over upper and lower linkage pins. A second lower link con-
nection is provided as standard and allows a higher attachment height to the tractor
of approx. 140mm. The upper and lower pins must be secured in place with the
linchpins attached to the spreader.
For correct horizontal spreading of fertilizer, the fertilizer spreader must be attached
as per dimensions given in the spreading charts.
Pay attention that the spreader is mounted at right angles to the direction of travel, is
perfectly horizontal and that the 3-point frame is correctly restrained from sideways
movement to avoid the unit swinging from side to side during operation.
Important: If the lower link pins are in the upper connection point then the top
link pin must also be placed in its upper connection point, to avoid poor load dis-
tribution between upper and lower links.
2.2 Parking the fertilizer spreader
The spreader can be parked on the frame, support rollers or parking stand (support
rollers & parking stand are optional equipment).
When parking the spreader pay attention to the following :
♦
When operating the external tractor 3-point lift control lever, do not stand between
the tractor and the spreader.
♦
Before uncoupling the spreader from the tractor make sure that all weight from the
upper and lower linkage coupling points is relieved.
♦
Only park the spreader when the hopper is empty and on a firm level surface.
♦
After disconnecting PTO shaft and hydraulic hoses from the tractor, place them in
the holders provided on the spreader.