Kubota ZD221, Operator'S Manual

Page: 92 / 95

75 TROUBLESHOOTING
ENGLISH
BATTERY TROUBLESHOOTING
If you have any questions, contact your local KUBOTA Dealer.
MACHINE TROUBLESHOOTING
If you have any questions, contact your local KUBOTA Dealer.
Trouble Cause Countermeasure Preventive measure
Starter does not function.
A
Battery overused until
lights are dim.
A
Charge battery
sufficiently.
A
Charge the battery properly.
A
Battery has not been
recharged.
A
Poor terminal
connection.
A
Clean the terminal
and tighten securely.
A
Keep the terminal clean and
tight.
Apply grease and treat with
anti-corrosives.
A
Battery life expired.
A
Renew battery.
From beginning starter
does not function, and
lights soon become dim.
A
Insufficient charging.
A
Charge battery
sufficiently.
A
Battery must be serviced
properly before initial use.
When viewed from top,
the top of plates look
whitish.
A
Battery was used with
an insufficient amount
of electrolyte.
A
Add distilled water
and charge the
battery.
A
Regularly check the
electrolyte level.
A
Battery was used too
much without
recharging.
A
Charge battery
sufficiently.
A
Charge the battery properly.
Recharging is impossible.
A
Battery life expired.
A
Replace battery.
Terminals are severely
corroded and heat up.
A
Poor terminal
connection.
A
Clean the terminal
and tighten securely.
A
Keep the terminal clean and
tight.
Apply grease and treat with
anti-corrosives.
Battery electrolyte level
drops rapidly.
A
There is a crack or pin
holes in the electrolytic
cells.
A
Replace battery.
A
Charging system
trouble.
A
Contact your local
KUBOTA Dealer.
Trouble Cause Countermeasure
Machine operation is not
smooth.
A
Hydrostatic transmission fluid is
insufficient.
A
Replenish oil.
A
Filter is clogged.
A
Replace the filter.
Machine dose not move while
engine is running.
A
Parking brake is on.
A
Release the parking brake.
A
Transmission fluid level is
insufficient.
A
Replenish oil.
Machine moves when motion
control levers are in "NEUTRAL
LOCK" position.
(Engine is operated.)
A
Motion control rod is not correctly
adjusted.
A
Ask your dealer for hydrostatic lever
linkage adjustment or pressure
adjustment.
A
Control linkage pivots are sticking.
A
Full up and lubricate linkage.