Kubota ZD221, Operator'S Manual

Page: 61 / 95

PERIODIC SERVICE 44
ENGLISH
B
Inflation Pressure
Though the inflation pressure is factory-set to the
prescribed level, it naturally drops slowly in the course of
time. Thus, check it and inflate as necessary.
B
Checking Transmission Fluid Level
1. Park the machine on a flat surface, lower the
implement to the ground and shut off the engine and
remove the key.
Allow the machine to idle for 1-3 minutes, and then
check fluid.
2. Raise and lock the operator's seat.
3. To check the oil level, draw out the dipstick, wipe it
clean, replace it, and draw it out again. Check to see
that the oil level lies between the two notches.
If the level is too low, add the new oil to the prescribed
level at the oil inlet.
(See "LUBRICANTS AND FUEL" in "MAINTENANCE"
section.)
A
If oil level is low, do not run engine.
Tire sizes
Recommended Inflation
Max. Pressure
Front
13 x 5.0 - 6,
4PR Rib
276 kPa
(2.8 kgf/cm , 40 psi)
Rear
23 x 10.5 - 12,
4PR Turf
140 kPa
(1.4 kgf/cm , 20 psi)
(1) Ground (A) "INSUFFICIENT"
(B) "NORMAL"
(C) "EXCESSIVE"
(1) Oil level dipstick (A) Oil level is acceptable
(2) Oil plug and breather cup within this range.