SAFE OPERATION
-
4
ENGLISH
7. Use special caution when changing direction on
slopes. Slow down, and use extra caution when
changing direction on a slope.
DO NOT
1. Do not turn on slopes unless necessary. If necessary,
turn uphill slowly and gradually.
2. Do not mow near drop-offs, ditches, or embankments.
The mower could suddenly turn over if a wheel is over
the edge of cliff or ditch, or if an edge caves in.
3. Do not mow on wet grass. Reduced traction could
cause sliding and loss of control.
4. Do not try to stabilize the machine by putting your foot
on the ground.
5. Do not use grass catcher on steep slopes.
6. Do not start or stop suddenly on slopes. If tires lose
traction, disengage PTO and proceed slowly straight
down the slope.
7. Never "freewheel". Do not let the machine travel
downhill with motion control levers at neutral lock
position or in neutral.
8. Do not operate machine without the mower deck
installed.
C
Stopping
1. Park the machine on level ground.
2. Make sure that the machine and all attachments have
come to a complete stop before you get off.
3. Before you get off, apply parking brake, place the
motion control levers in their neutral lock positions,
disengage the PTO, lower all attachments to the
ground, turn off the engine, and remove the key.
4. Do not park the machine on dry grass or leaves.
1. Before installing or using PTO-driven equipment, read
the manufacturer's manual and review the safety
labels attached to the equipment.
2. Wait until all moving components have completely
stopped before connecting, disconnecting, adjusting,
cleaning, or servicing any PTO-driven equipment.
3. Use the PTO with KUBOTA approved attachments.
The speed of PTO:
ZD1011 / ZD1021 Without mower: 2450 to 2550 rpm at
3200 engine rpm
1. Use lift link only with authorized attachments designed
for lift link usage.
1. Disengage power to attachment(s) when transporting
or not in use.
2. Do not tow this machine. Use a suitable truck or trailer
when transporting on public roads.
3. Use extra care when loading or unloading the machine
into a trailer or truck. Use full width ramps for loading
machine into trailer or truck.
4. This machine is not allowed to be used on public
roads.
5. Shut off fuel while storing or transporting.
6. Tie the machine down securely using straps, chains,
cable, or ropes.
7. Both front and rear straps must be directed down and
outward from the machine.
C
Servicing
1. Before servicing, park the machine on a firm, level
surface and apply the parking brake. Remove the key
to prevent accidental start-up.
2. Allow the machine time to cool before touching the
engine, muffler, radiator, etc.
3. Always stop the engine before refueling. Avoid spills
and overfilling. Wipe up spilled fuel immediately.
4. Use extra care in handling diesel fuels. They are
flammable.
(1) Use only an approved container.
(2) Do not remove fuel cap or refuel with the engine
running. Allow engine to cool before refueling. Do
not smoke while refueling or when standing near
fuel.
(3) Do not refuel the machine indoors and always
clean up spilled fuel or oil.
(4) Do not store the machine or fuel container inside
where there is an open flame, such as in a water
heater.
3. USING THE PTO
4. USING THE LIFT LINK
5. TRANSPORTING
6. SERVICING AND STORAGE
(1) Fuel tank cap
