p. 5 of 18
1.7 Per fig. 1.7, remove and discard the two original
equipment bolts and nuts from the front ROPS (Roll-
Over Protective Structure) tubing. New bolts, nuts, and
steel bushings are provided. Have the following hard-
ware ready: two 3/8-16 x 1-3/4” long button head bolts,
two steel bushings, and two locknuts (3/8-16). Per fig.
1.7, orient and install the front mount on the driver’s side
as follows: the steel bushings are to be installed in the
upper outside cavity and the lower inside cavity. These
are to fill voids and support the ears on the front mount.
See fig. 1.7.1 for a completed view of this assembly. In-
stall the new nuts into the open cavities. Install the new
bolts through the ears of the front mount, through the
steel bushings, through the ROPS tubing and engage into
each of the locknuts.
1.8 Repeat step 1.7 for passenger’s side.
1.9 Torque these four (2/side) front mount bolts to 48-
55 N-m, 36-41 ft-lbs, or 4.9-5.7 kgf-m.
Fig. 1.7.1 (view of driver’s side front mount from driv-
er’s seat)
Fig. 1.7 (view of driver’s side from driver’s seat)
remove and discard
original equipment
bolts and nuts from
this joint
ears
bushing
locknut
ref.: inside surface
of ROPS tubing)
note: steel bushing
is underneath this
sheet metal ear
ref.:
nut
ref.: this tab to
be down here
as shown
Summary of Contents for RTV 400 CAB
