Kubota RTV 400 CAB, Installation & Owner'S Manual, Page: 8 / 18

2.4 Note: the entire bottom portion of the windshield
assembly is designed to pivot up and out of the way when the
hood needs to be opened. On each side of the cowl there is a
finger pull pin. Disengage and re-engage accordingly. Note:
it may be necessary to squeeze the cowl to compress the rub-
ber gasket in order to get the pins to re-engage.
2.5 Tip: removal of any component that has latches can
be made easier for a single person if the latch is opened to
disengage the receiving pin then manually closed as shown
in fig. 2.5 so the weight of the component does not cause the
latch to continually re-engage on the receiver pin when you
try to work the opposite side of the vehicle by yourself. Push
at location “c” to close and pull at location “o” to open. Be
sure to open latches before re-installing.
p. 8 of 18
Condition: Explanation/Solution
Latches will not double click
Be sure upper pins are fully
seated in slots of upper mounts.
Move
latches backward in slots.
Gap along ROPS at bottom
Move latches forward.
Gap along ROPS at top
Move upper pins forward.
Gap along hood
Move latches forward.
Move lower pins down.
Move upper pins up.
Troubleshooting the windshield
Fig. 2.4 (hood access)
finger pull pin
Fig. 2.5 (latch shown closed)
location “o”
to open
location “c”
to close
CLOSED