Coupling the machine
33
Adjusting the
drawbar cylinder
The drawbar cylinder is used to adjust the height of the drawbar and
the machine pitch so that the crop can be picked up satisfactorily. The
drawbar cylinder is adjusted differently depending on the equipment:
Proceed as follows.
Operation without optional support wheel:
Fully screw in the spindle on the drawbar cylinder.
Set the tractor's hydraulic control device to the floating position.
When the optionally available support wheel is used, the spindle on
the drawbar cylinder must be adjusted to compensate for the ground
undulations.
Operation with optional support wheel:
Unscrew the spindle on the drawbar cylinder by about 20 mm.
Spanner size "17" on the spindle
In the case of the optional support wheel, ensure that a lift of at least
10 mm is always guaranteed for the drawbar cylinder.
Spindle
Drawbar cylinder
Spindle
20 mm
Drawbar cylinder
