Kubota L3301, Operator'S Manual

Page: 108 / 139

[Manual transmission type]
[HST type]
(1) PTO gear shift lever
1. Sit on the operator's seat.
2. Start the engine.
3. Engage the PTO-gear-shift-lever.
4. Stand up.
Do not get off the machine.
5. Make sure that the engine shuts off after
approximately 1 second.
6. If the engine does not stop, consult your local
KUBOTA Dealer for servicing the operator's seat.
6. Checking the wheel bolt torque
WARNING
To avoid personal injury or death:
• Never operate the tractor with a loose rim,
wheel, or axle.
• Any time that the bolts and nuts are loosened,
retighten them to the specified torque.
• Check all bolts and nuts frequently and keep
them tight.
1. Check the wheel bolts and nuts regularly especially
when they are new.
2. If the bolts and nuts of the wheels are loose, tighten
them as follows.
(1) Bolt (front wheel) (2) Bolt (rear wheel)
Bolt (front wheel) (1)
Tightening torque
137.0 N ⋅ m
(14 kgf ⋅ m)
[100 ft
⋅
lbs]
Bolt (rear wheel) (2)
215.0 N
⋅
m
(22 kgf ⋅ m)
[160 ft
⋅
lbs]
SERVICE EVERY 100 HOURS
1. Cleaning the air cleaner element
[Single element type]
IMPORTANT :
• The air cleaner uses a dry element. Never apply
oil.
• Do not run the engine with filter element
removed.
(1) Elements
(2) Cover (3) Evacuator valve
1. Remove the element.
2. Clean the element.
3. When dry dust adheres to the element, blow
compressed air from the inside, turning the
element. Pressure of compressed air must be
under the following value.
PERIODIC SERVICE SERVICE EVERY 50 HOURS
104
L3301,L3901