Kubota Impac 500, Owner'S Manual

Page: 11 / 28

INSTALLATION INSTRUCTIONS
(cont…)
Step 9 – Install the 12V DC 103 HPU Starter 4-Pole Solenoid Part# EZ502 inside battery
storage compartment located under the c argo bed . You will need to drill two 1/4”
holes to mount Starter Solenoid to the inside of the battery storage compartment .
{Use 2pcs – Part# EZ872 Hexagon Head Cap Screw S.S. (1/4”-20 x 1/2” Long) and 2pcs –
Part# EZ631 Nylon Nut (1/4”-20)}
Step 10 – Place the Fuse Block next to the 4-Pole
Solenoid way about 2” mark the holes on the Fuse
Block onto the battery storage compartment.
Step 1 2 – Install the Wire Part# WG160
6 inch Power Red Wire to the silver colored
#10 post on the Block Fuse 50 Amp and
run it to the 5/16” post on the 4-Pole
Solenoid.
Page 9
Step 11 - Drill the mark holes with a 1/4" drill bit. Mount the resetting fuse Part # EZ677.
{Use 2pcs – Part# EZ609 Phillips Head Cap Screw S.S. (#10-32 x 3/4” Long) and 2pcs – Part# EZ661
Nylon Nut (#10-32).} {As shown above}
Step 1 3 – Install the Wire Part# WG1 63 12 inch Ground Green Wire to Batteries
Ground terminal and run it to the #10 post on the 4-Pole Solenoid by pushing it in
through the existing wiring going into the center storage compartment under the
seat. {As shown above}
Step 1 4 – Install the Wire Part# WG1 62 24 inch Red Power Wire to the
Batteries Power terminal and run to the copper colored #10 post on the
Block Fuse 50 Amp by pushing it in through the existing wiring going into
the center storage compartment under the seat.
Step 1 5 – Open the Kubota cargo bed outward to connect the Wire Part# WG16 4 72 inch Ignition
Power Wire to the ignition terminal cable to the #10 post on the 4-Pole Solenoid. Run it over the
engine make sure you are not on any hot spots touching the wire.