Section 1: Assembly & Set-up
AP-SC4060 & AP-SC4072 Skid Steer Rotary Cutters 326-765MK
12/14/18
11
Hydraulic Hose Hook-up
Refer to Figure 1-4 on page 10:
.
1.
If attaching to a Kubota SVL or SSV machine, be sure
to route hydraulic hoses through hose loop (#1) on
the left side of the cutter hitch as shown.
Hose Route For Kubota SVL or SSV Machine (SVL Shown)
Figure 1-6
Refer to Figure 1-4 on page 10:
2. Thread hoses through any hose holders that may be
helpful on the machine operating the cutter. See your
skid steer Operator’s Manual for instruction on how to
use these hose holders.
3. Connect male and female couplers on the cutter to
the appropriate skid steer flat faced couplers.
4. Operate skid steer to check blade rotation. The SC40
is designed to have cutter blades rotate clockwise or
counter clockwise.
5. Zip tie hydraulic hoses together every 2 feet from
male and female couplers.
IMPORTANT:
Customer to select best way to route
hydraulic hoses. Make sure hoses will not contact
the skid steer wheels or tracks. See
on page 16 for detailed instructions on
how to check for clearances.
NOTE:
Use of Kubota’s SVL Hose Stay is not
recommended for this attachment.
70030
1
Do Not Use
SVL Hose Stay
Front Roller Assembly (Optional)
Refer to Figure 1-7:
.
1.
Raise the cutter and secure with support blocks.
2. Insert four 1/2"-13X1 1/2" carriage bolts (#5) through
the square holes in the front roller assembly’s
mounting plate (#4) and through the holes in the
cutter deck as shown.
3. Secure carriage bolts (#5) with flat washers (#3), lock
washers (#2) and 1/2-13 hex nuts (#1). Hand tighten.
4. Make sure that the roller assembly (#4) is lined up
straight. Tighten hex nuts (#1) to correct torque.
5. Repeat steps 2 through 4 for the second roller
assembly.
6. Raise the cutter off of the support blocks and set
back on the ground.
Front Roller Wheel Assembly
Figure 1-7
39986
