STEP 7: Front Side Header Assemblies
7.1
For each side, one side at a time, remove and retain the M10 bolt at the underside of the front end of the
front ROPS cross member, and the M10 bolt at the top of the ROPS above the B
-
pillar (see Figure 7.1).
7.2
Place each front side header over the ROPS and secure it to the underside of the ROPS with the removed
M10 bolt.
7.3
Install the M10 bolt removed in step 6.2 through the front header and B
-
pillar panel and into the ROPS.
Tighten both M10 bolts snug but do not apply final torque.
NOTE: The front header will be secured to the windshield frame after the rear doors are installed and adjusted.
The M10 bolt in the top of the ROPS will be installed with the canopy.
INSTALLATION
13
Figure 7.1: Front Side Headers (Driver
’
s side shown)
M10 Bolt:
Remove and
re
-
use
M10 Bolt
from step 6.2
M10 Bolt:
Remove and discard
(retain if Canopy had been installed)
Assemble
later
