STEP 6: B
-
Pillar Panels
6.1
For each side, remove and retain both M12 bolts at the base of the center, side pillar of the ROPS
(see Figure 6.1)
6.2
For each side, remove and retain the M10 bolt from the side of the ROPS, just forward of the center
pillar (see Figure 6.2). These bolts will be used later to secure the front side headers.
6.3
Place the B
-
Pillar over the center side ROPS pillar and secure it with the removed M12 bolts.
6.4
Adjust the B
-
pillar to be centered in the slots with the lower section of the B
-
pillar as close to parallel to
the ROPS as possible. Tighten the M12 bolts snug but do not apply final torque.
6.5
Install a floorboard bracket at the corner above the floorboard and inside the B
-
pillar (see Figure 6.1).
Attach the bracket to the B
-
pillar with (3) 5/16
-
18 X
3/4”
flanged button head bolts and nuts inside.
Push the B
-
pillar against the floorboard to remove any gap and secure the bracket to the floorboard
with (2) 5/16
-
18 X
3/4”
flanged button head bolts and nuts underneath. Tighten snug but do not apply
final torque.
6.6
Repeat for the other side.
INSTALLATION
12
Figure 6.1: B
-
Pillar center and lower bolts
Figure 6.2: B
-
Pillar upper M10 bolt
M12 Bolts:
Remove and
re
-
use
M10 Bolt:
Remove and
retain
5/16
-
18 Nuts
5/16
-
18 Bolts
5/16
-
18 Bolts
5/16
-
18
Fender
Washers
B
-
Pillar Panel
Floorboard
Bracket