Kübler Group
6 Annex
Manual IO-Link interface - R67071.0002 - 02
EN - 57
Individual parameterizing
Block parameterizing
a1:
If the TMR is modified, the preset is set to 0 if
it is larger than or equal to TMR.
a1:
If the TMR is modified, the preset is set to 0 if
it is larger than or equal to TMR, provided the
preset did not change. Otherwise, the new
value is taken over.
a2:
If the TMR is modified, the position lower limit
is set to 0 and the position upper limit is set to
TMR-1.
a2:
If the TMR is modified, the position lower limit
is set to 0 and the position upper is set to
TMR-1, provided they did not change.
Otherwise, the new value is taken over.
z1:
Position upper limit >= Position lower limit.
z1:
Position upper limit >= Position lower limit.
z2:
Either Scaling or Endless shaft can be
activated.
z2:
Either Scaling or Endless shaft can be
activated.
z3:
If Scaling is active, the ratio of TMR and MUR
must be a 2
n
ratio.
z3:
If Scaling is active, the ratio of TMR and MUR
must be a 2
n
ratio.
z4:
If Endless shaft is active, the ratio of TMR,
numerator and divisor must match.
z4:
If Endless shaft is active, the ratio of TMR,
numerator and divisor must match.
z5:
Maximum allowed value: TMR-1.
z5:
Maximum allowed value: TMR-1.
