8.3 Troubleshooting of the KTM PowerPack when connected to the charger
Fault
Blink
code
Measure 1
Measure 2
Measure 3
Overtemperature of the
KTM PowerPack
33
Let the KTM PowerPack cool
down
Continue charging in
a cooler location
Contact an authorized
KTM workshop
The KTM PowerPack is
too cold
34
Place the KTM PowerPack in a
warmer location and let it warm
up
Continue charging in
a warmer location
Contact an authorized
KTM workshop
The KTM PowerPack is
too cold
36
Place the KTM PowerPack in a
warmer location and let it warm
up
Continue charging in
a warmer location
Contact an authorized
KTM workshop
Fault in the charging
cable
65
Check the charging plug and
charging cable for external dam-
age and reconnect
Contact an autho-
rized KTM workshop
The charge state of the
KTM PowerPack is too
high for the "Storage"
charge mode
66
Ride the vehicle until the
KTM PowerPack is depleted to
50%
Contact an autho-
rized KTM workshop
Charging fault
11
Check the charging plug and
charging cable for external dam-
age and reconnect
Contact an autho-
rized KTM workshop
If LED
1
flashes, there is a KTM PowerPack fault.
All of the following blink codes are displayed on the charger
and refer to the KTM PowerPack.
-
Read out the fault.
-
Switch off the charger.
-
Wait 15 seconds.
-
Remedy the fault as instructed in the table.
-
Switch on the charger.
Important
For all faults that are not listed in the table, switch the charger off and on again. If this does not eliminate the fault, con-
tact an authorized KTM workshop.
The pause between the signal of the 1st digit is 0.25 seconds.
The pause between the 1st and 2nd digits is 1 second.
The pause until the blink code repeats is 3 seconds.
The following example shows blink code 31:
22
8 TROUBLESHOOTING
