8.1 Vehicle troubleshooting
The blink codes are displayed by the yellow electric motor indicator lamp.
The following example shows blink code 31:
Fault
Blink
code
Measure 1
Measure 2
Measure 3
Measure 4
Switch-off due to low
charge state
11
Charge the
KTM PowerPack
Test the new
KTM PowerPack
Contact an authorized
KTM workshop
Fault during charging
13
Stop charging,
switch off the main
switch, and restart
charging
Contact an
authorized KTM
workshop
Overtemperature of the
control unit
22
Check the coolant
level
Check the radiator
for dirt
Contact an authorized
KTM workshop
Overtemperature of the
motor
23
Check the coolant
level
Check the radiator
for dirt
Contact an authorized
KTM workshop
Overtemperature of the
KTM PowerPack
24
Let the KTM Power-
Pack cool down
Contact an
authorized KTM
workshop
Fault in the CAN com-
munication
31
Switch the main
switch off and on
Check the correct
positioning of the
KTM PowerPack
Check the connection
of the multifunction
display for loose con-
nectors
Contact an au-
thorized KTM
workshop
Fault in the com-
munication with the
KTM PowerPack
33
Switch the main
switch off and on
Check the correct
positioning of the
KTM PowerPack
Contact an authorized
KTM workshop
Fault in the communi-
cation with the multi-
function display
34
Switch the main
switch off and on
Check the con-
nection of the
multifunction
display for loose
connectors
Contact an authorized
KTM workshop
The pause between the signal of the 1st digit is 0.25 seconds.
The pause between the 1st and 2nd digits is 1 second.
The pause until the blink code repeats is 3 seconds.
Important
For all faults that do not appear in the table, switch the vehicle off and on again. If this does not eliminate the fault, con-
tact an authorized KTM workshop.
19
8 TROUBLESHOOTING
