KTM F5375T5, Owner'S Manual

Page: 25 / 287

SAFETY ADVICE 2
23
2.14 Work rules
Unless specified otherwise, the ignition must be turned off during all work (models with ignition lock, models
with remote key) or the engine must be at a standstill (models without ignition lock or remote key).
Special tools are necessary for certain tasks. The tools are not a component of the vehicle, but can be ordered
using the number in parentheses. Example: bearing puller (15112017000)
During assembly, use new parts to replace parts which cannot be reused (e.g. self-locking screws and nuts,
expansion screws, seals, sealing rings, O-rings, pins, and lock washers).
In the case of certain screws, a screw adhesive (e.g.
Loctite ® ) is required. Observe the manufacturer's instruc-
tions.
If thread locker (e.g.,
Precote ® ) has already been applied to a new part, do not apply any additional thread locker.
After disassembly, clean the parts that are to be reused and check them for damage and wear. Change damaged
or worn parts.
After completing a repair or service work, check the operating safety of the vehicle.
2.15 Environment
If you use your motorcycle responsibly, you can ensure that problems and conflicts do not occur. To protect the
future of the motorcycle sport, make sure that you use your motorcycle legally, display environmental conscious-
ness, and respect the rights of others.
When disposing of used oil, other operating and auxiliary fluids, and used components, comply with the laws and
regulations of the respective country.
Because motorcycles are not subject to the EU regulations governing the disposal of used vehicles, there are no
legal regulations that pertain to the disposal of an end-of-life motorcycle. Your authorized KTM dealer will be glad
to advise you.