16
SERVICE WORK ON THE ENGINE
81
V00276-10
–
Turn oil pump gear
counterclockwise until oil flows out of oil line
without
bubbles.
300651-10
–
Connect oil line
.
–
Position the oil pump.
–
Mount and tighten screws
.
Guideline
Screw, oil pump
M5
6 Nm (4.4 lbf ft)
16.3
Checking the gear oil level
Condition
The engine is cold.
Preparatory work
–
Stand the motorcycle upright on a horizontal surface.
H00083-10
Main work
(50 SX)
–
Remove gear oil monitoring screw
.
–
Check the gear oil level.
A small amount of gear oil should flow out.
» If no gear oil runs out:
–
Add gear oil.
–
Mount and tighten the gear oil monitoring screw.
Guideline
Screw, gear oil level check
M6
6 Nm (4.4 lbf ft)
S00882-10
(50 SX Mini)
–
Remove gear oil monitoring screw
.
–
Check the gear oil level.
A small amount of gear oil should flow out.
» If no gear oil runs out:
–
Add gear oil.
–
Mount and tighten the gear oil monitoring screw.
Guideline
Screw, gear oil level check
M6
6 Nm (4.4 lbf ft)
16.4
Changing the gear oil
Warning
Danger of scalding
Engine and gear oil get very hot when the motorcycle is ridden.
–
Wear suitable protective clothing and safety gloves.
–
In the event of scalding, rinse the area affected immediately with lukewarm water.
Warning
Environmental hazard
Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with the applicable regu-
lations.
Summary of Contents for 50 SX 2017
Page 1: ...OWNER S MANUAL 2017 50 SX 50 SX Mini Art no 3213469en...
Page 2: ......
