KTM 50 SX 2017, Owner'S Manual

Page: 37 / 104

11 SERVICE WORK ON THE CHASSIS
35
11.4 Cleaning the dust boots of the fork legs
Preparatory work
–
Raise the motorcycle with a lift stand. ( p. 34)
–
Remove the fork protector. ( p. 35)
S00886-10
Main work
–
Push dust boots

of both fork legs downward.
Info
The dust boots remove dust and coarse dirt particles from the inside fork
tubes. Over time, dirt can accumulate behind the dust boots. If this dirt is
not removed, the shaft seal rings behind can start to leak.
Warning
Danger of accidents Oil or grease on the brake discs reduces the braking
effect.
–
Always keep the brake discs free of oil and grease.
–
Clean the brake discs with brake cleaner when necessary.
–
Clean and oil the dust boots and inner fork tube of both fork legs.
Universal oil spray ( p. 96)
–
Press the dust boots back into their normal position.
–
Remove excess oil.
Finishing work
–
Install the fork protector. ( p. 35)
–
Remove the motorcycle from the lift stand. ( p. 34)
11.5 Removing the fork protector
V00266-10
–
Remove screws

and take off the clamp.
–
Remove screws

on the left fork leg. Take off the fork protector.
V00267-11
–
Remove screws

on the right fork leg. Take off the fork protector.
11.6 Installing the fork protector
V00267-10
–
Position the fork protector on the right fork leg. Mount and tighten screws

.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)