KTM 250 EXC-F AUS 2012, Setup Instructions

Page: 8 / 18

SETUP
6
601710-01
–
Secure the handlebar cushion with two cable binders.
101019-01
–
Mount the footrests with the springs and bolts. Secure the bolts using the washers
and pins.
Pliers for footrest spring (58429083000)
601711-01
–
Mount the license plate holder with the license plate lamp, turn signals, and reflec-
tor.
–
Connect the electrical components.
–
Connect the connector of the left turn signal with connector that is marked red.
–
Connect the connector of the right turn signal with connector that is marked green.
800035-10
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep the battery away from sparks or open flames. Charge only in well-
ventilated areas.
–
In the event of skin contact, rinse with large amounts of water. If battery
acid gets in the eyes, rinse with water for at least 15 minutes and con-
tact a physician.
–
Fill the battery.
Info
Read the notes in the battery package.
–
Charge the battery. ( p. 10)
–
Install the battery. ( p. 9)
–
Unpack and mount the KTM PowerParts included in the delivery (optional).
Info
Read the accompanying
KTM PowerParts
installation instructions.
–
Apply the label included in the delivery (optional).
–
Refuel. ( p. 11)
–
Position all controls in their exact positions on the handlebar. Tighten all screws.
–
Print out the current PDI form found on KTM DEALER.NET and perform the delivery
inspection.