KTM 250 EXC-F AUS 2012, Setup Instructions

Page: 6 / 18

SETUP
4
C00115-10
(XCF
‑
W)
–
Insert the indicator lamp with the brown/red and yellow/blue cable colors
into socket
3
.
–
Insert indicator lamp LED with the white and orange cable colors into
socket
4
.
–
Connect pull switch
5
with the yellow and white cables.
401380-01
(All EXC
‑
F models)
–
Attach the retaining bracket for the connector, the turn signal bracket with
the turn signal, and the speedometer to the upper triple clamp.
Guideline
Remaining screws, chassis M6 10 Nm
(7.4 lbf ft)
401381-01
(XCF
‑
W)
–
Attach the speedometer to the upper triple clamp.
Guideline
Remaining screws, chassis M6 10 Nm
(7.4 lbf ft)
601705-10
(All EXC
‑
F models)
–
Mount and tighten nuts
5
of the turn signals on both sides.
–
Connect connector
6
of the right turn signal with connector
7
, which is
marked green.
–
Connect connector
8
of the left turn signal with connector
9
, which is
marked red.
601707-10
–
Route the clutch line with the clutch master cylinder toward the front between
the upper and lower triple clamps.
–
Position the fork legs and tighten the screws of the triple clamp.
Guideline
Screw, top triple clamp (XCF
‑
W,
EXC
‑
F EU, EXC
‑
F AUS)
M8 20 Nm
(14.8 lbf ft)
Screw, bottom triple clamp (XCF
‑
W,
EXC
‑
F EU, EXC
‑
F AUS)
M8 15 Nm
(11.1 lbf ft)
Screw, top triple clamp (EXC-F SIX
DAYS) M8 17 Nm
(12.5 lbf ft)
Screw, bottom triple clamp (EXC-F
SIX DAYS) M8 12 Nm
(8.9 lbf ft)
Info
The topmost milled groove in the fork leg must be flush with the top
edge of the upper triple clamp.
Position bleeder screws
bk
toward the front.