CONFIDENTIAL - This document is the property of K.T.C. S.r.l. and cannot be reproduced or issued to third parties without written
authorization. K.T.C. S.r.l. shall safeguard its rights to the full extent of the law.
OPERATION AND INSTALLATION MANUAL
COD. 091114 – COMPACK 2 ECO / SPECIAL - REV. 08 - DATE 10/2020
page
55
of
63
10.6
MAINTENANCE SCHEDULE
The following table shows a plan for maintenance of the compressor.
The working hours shown in the table refer to an optimal use of the machine and therefore may vary
according to the work environment and the number of cycles.
The
Manufacturer
recommends keeping a log of the maintenance works performed on the
compressor.
MS: Maintenance staff
SP: Service and distribution partners KTC
Component
Verification
Maintenance
Control Type
HOURS
DESCRIPTION OF OPERATION
Operator control /
maintenance
compressor Unit
Visual
Daily
General Inspection unit
MS
Component
Verification
Maintenance
Control Type
HOURS
DESCRIPTION OF OPERATION
Operator control /
maintenance
Oil level
Control
Weekly
level Control
MS
Prefilter air intake
Control
General control and cleaning (if
necessary)
Oil radiators / air
Control
Cleaning (if necessary) of the
radiators from various material /
powder / oil residues, etc.
Component
Verification
Maintenance
Control Type
HOURS
DESCRIPTION OF OPERATION
Operator control /
maintenance
Oil filter
Replacement
500 /
6 months
Replacing the oil filter and oil
recovery level
SP
Electric / remote
control switch panel
Control and
tightening
Terminals main electrical panel
terminals and contactors star /
delta
Pipes, fittings,
components
Control
Visual inspection leaks oil / air
Belt drive
Control
(where
present)
belt tensioning control and
eventual
Oil cooler
Control
Control of the cooling system
efficiency and / temperature
