Quick Installation Guide KNR-p4Px4 KVR-p16Px8
2
Thank you for purchasing our product. If there is any question or request, please do not hesitate to contact your dealer.
KT&C Certified Dealers can contact KT&C directly.
Series
Model
Type
Omni IP
KNR-p4Px4
KNR-p16Px8
Network Video Recorder
NVR Pre-Installation
The Omni IP series KNR-p4Px4 & KNR-p16Px8 NVRs are highly advanced surveillance equipment that should be
installed with care. Please take into consideration the following precautionary steps before installation of the NVR.
1.
Keep all liquids away from the NVR.
2.
Install the NVR in a well-ventilated and dust-free area.
3.
Ensure environmental conditions meet factory specifications.
4.
Install a manufacturer recommended HDD.
NVR Installation
During the installation of the NVR:
1.
Use the optional KA-ORM1 brackets for rack mounting.
2.
Ensure there is ample room for audio and video cables.
3.
When installing cables, ensure that the bend radius of the cables are no less than five times than its diameter.
4.
Connect RS-485 cable if required.
5.
Allow at least 2cm (~0.75-inch) of space between racks mounted devices.
6.
Ensure the NVR is grounded.
7.
Environmental temperature should be within the range of -10
ºC ~ 55
ºC, 14ºF ~ 131ºF.
8.
Environmental humidity should be within the range of 10% ~ 90%.
Hard Disk Installation
Before you start:
Before installing a hard disk drive (HDD), please make sure the power is disconnected from the NVR. A factory
recommended HDD should be used for this installation.
Up to 2 SATA hard disks can be installed on your NVR.
Tools Required:
Screwdriver.
For
KNR-p4Px4 & KNR-p16Px8
:
1.
Remove the cover from the NVR by unfastening the screws on the back and side.
2.
Connect one end of the data cable to the motherboard of NVR and the other end to the HDD.
