23
4.3
Parameters setting
The setting function is controlled by 3 buttons (Enter
, Off ▲, On ▼):
Enter
---
goes into the setting page and value adjustment; Off ▲ & On
▼
---for choosing different pages.
After the UPS turn ON, press buttons
& ▲ for 3 seconds and then
goes
into the setting interface page. After finishing setting the parameter, press
“ON” until exiting out of the current interface.
Note: Figure at left corner is the page number of the setting pages. After
entering the setting interface, it will exit when without operation in 30s.
4.3.1 Mode setting
Mode setting (Note: Inside the broken-line is the flashing part.)
After entering the setting menu, it’s mode setting defaulted, and the mode
setting line flashing as in above picture.
•
Use button Enter
to choose different mode. There are 3
different modes for setting: ECO, PAL, NOR.
•
P
ress▲ or ▼ to exit the mode setting (save
the mode setting),
and goes to output voltage setting or parallel redundancy quantity
setting.
