code R30020.100en www.kseniasecurity.com
ed.04/2020
CONFIGURATION OF RADIO MODULE USING LARES 4.0 CONTROL PANEL
In order to work with the lares 4.0 control panels, auxi wls has to be enrolled as peripheral. The different
ways to enroll an auxi wls are described here below:
1. Insert the serial number of auxi wls directly from basis software
2. Set the panel on ‘Enrolling’ mode and power up the auxi wls
3. Set the panel on ‘Enrolling’ mode and press shortly on programming button on auxi wls
The outputs and the inputs can be programmed as normally open or normally closed.
Please refer to the lares 4.0 Programming Manual for more details.
CONFIGURATION OF RADIO MODULE AS STAND-ALONE DEVICE
In order to program auxi wls as stand-alone device, at least an opera remote command has to be memorized.
The procedures to memorize an opera remote command and to program the relay outputs are described
here below.
MEMORIZE OPERA REMOTE COMMANDS
In order to program the remote commands, hold the programming button on auxi wls for 3 seconds. The led
on device stays lit to confirm the access on programming mode. Hold the key “i” on remote command for 3
seconds, in order to memorize it. The led on auxi wls blinks 4 times to confirm the memorization. It could be
useful to use the same opera to manage more auxi wls placed on the same radio operational range. To
do this, avoiding conflicts, just associate a single key of remote command to a single auxi wls. In order to
associate only one key to an auxi wls, press the key you want to associate (0, 1 or 2) within the 5 seconds
after the confirm of memorization. A memorized remote command can be deleted by holding for 3 second
the key. The led on auxi wls quickly blinks 2 couple of times in order to confirm the deleted remote
command.
PROGRAMMATION OF FUNCTIONS OF RELAY OUTPUTS
Once the memorization of remote commands is over, by holding for 3 seconds the programming button on
auxi wls, it switches from the programming of remote commands to the programming of outputs. While in
outputs programming mode, the led on auxi wls blinks regularly (half a second ON, half a second OFF). At
this point, a memorized remote command can be used to program the outputs. Please see the tables here
below to program the outputs.