code R30020.100en www.kseniasecurity.com
ed.04/2020
OUTPUTS MANAGEMENT THROUGH OPERA REMOTE COMMANDS (STAND-ALONE)
What follows is valid only for using auxi wls as stand-alone device. To manage outputs with opera remote
command it is necessary to enroll it. As explained in ‘Programming’ paragraph, each key of remote
command can be associated with an auxi wls or 0-1-2 keys can be programmed to manage the relay outputs
of 3 different auxi wls. To associate a single key of remote command to an auxi wls allows to manage up to
3 auxi wls at the same time, with the same remote command, if these are covered by the RF channel. In case
all the keys of opera remote command are associated to the same auxi wls, these operate as follows:
0 key
This key turns the 2 outputs in stay mode. This
action is confirmed by turning on the central LED on
opera
remote command.
1 key
This key manages the first relay output. By pressing
this key, the outputs react depending on the
programming.
• If the output is programmed as
monostable
it be
activated and remains active during the ON time. In
case the output is already active and programmed
as independent or SPTD (change over switch), the
ON time is re-started. Otherwise it turns off, if the
output is programmed as interlocked.
• If the output is programmed as
bistable
, it
commutates at every press on the key
To confirm the operation, opera remote command
turns ON its left LED, if the outputs is activated and
turns ON the central LED, if the output is
deactivated.
2 key
This key manage the second relay output By
pressing this key, the outputs react depending on
the programming.
• If the output is programmed as
monostable
it be
activated and remains active during the ON time. In
case the output is already active and programmed
as independent or SPTD (change over switch), the
ON time is re-started. Otherwise it turns off, if the
output is programmed as interlocked.
• If the output is programmed as
bistable
, it
commutates at every press on the key
To confirm the operation, opera remote command
turns ON its left LED, if the outputs is activated and
turns ON the central LED, if the output is
deactivated.
i key
This key allows to visualize the outputs status.
The short press on this key displays the status of the
first output. If the output is active, the left LED of
opera turns ON, otherwise it turns ON the central
one.
The long press on the same key (more than 3
seconds) displays the status of the second output in
the same way as the first one.
