TA
2D
|2
CHANNEL
POWER
AMP
TA
2D
|OPERATING
INSTRUCTIONS
7
|
P a g e
POWER-OUTPUTS /SPEAKON
There are 2 Neutrik®-speakON speaker level output connectors.
The handling of the signal, like equalization, crossover and
corrections of the transient attitudes of the components, are taking
place entirely in the integrated digital FIR controller. KS AUDIO is
offering numerous programs assuring best results no matter which
driver configuration has to be handled. All programs feature the
automatic adjustment and configuration of the output channel and
output signal which includes the limiting of the power been
supplied to the speakers.
The signal processing is entirely done in the digital domain. The digital connection is an AES3 port.
The amplifier and inputs accept analog sources as well. Highest end 27 bit Sigma-Delta- converters
in gain stacking along with a 64 times oversampling and a A-rated signal to noise ratio of >110dB
handle the conversion from analog into digital. The digital signals are operated by a floating point
DSP. The parameters which you can adjust from an
external control such as Delay and Room Equalization have direct access to the floating point level
of the sound processing and eliminates mistakes in scaling at this point.
KS recommends the use of 4x2,5
2
cable for all speaker to amplifier
connections for optimal performance
.
Warning – be certain that all speaker cables are wired identically at each end.
Two amplifiers being bridged together can create fatal damage to the
drivers.
We recommend to not using any other connectors than original
Neutrik® products.
* Inputs and outputs can be freely assigned via Controller, so input and
output channels may vary depending on your programming.
